Malaysian Plastics Manufacturers Association (MPMA) Facebook Page Malaysian Plastics Manufacturers Association (MPMA) Youtube Page Malaysian Plastics Manufacturers Association (MPMA) Instagram Page

Scientific Injection Moulding Trainings under the SME Skills Scheme

Pembangunan Sumber Manusia Berhad (PSMB) has appointed Malaysian Plastics Manufacturers Association (MPMA) as a Service Provider for the following courses under the SME Skills scheme:

  • Scientific Injection Moulding For Technicians Level 1 16 to 19 March 2020, Plasform Sdn Bhd, Kajang

    6 to 9 April 2020, Northern state, Venue to be confirmed

  • Scientific Injection Moulding For Senior Technicians Level 220 – 23 April 2020, Venue TBA

Dates:

This SME Skills training is open to all HRDF registered Employers as well as non-HRDF registered Employers who meet the official national SME definition as follow:

Sector Number of Employees
Manufacturing Less than 200 employees
Services & Other sectors Less than 75 employees

All HRDF registered and non-registered SME employers and their employees (trainees) are eligible to participate. However, each employee is only entitled to attend one approved course under the SME Skills scheme in order to provide opportunity for more employees to be trained. Each company can only train a maximum number of 5 employees to allow more companies to participate under the SME Skills scheme. Employers need to ensure all trainees complete their course and obtain certification of completion, failing which the employers are obligated to repay in full the course amount.

Training methodology & Course Content

Each level of training shall consist of online trainings and 4 days of classroom discussions and practical skills development. Participants are required to complete all prerequisite online trainings prior to attending the classroom discussions. Thereafter, participants must complete post-requisite online training and assessments before they are eligible to receive certification and their employers having fulfilled the obligation/agreement.

This trainings are specifically tailored for the plastics injection moulding manufacturers. Participants must complete the Scientific Injection Moulding for Technician course before they can attempt the Scientific Injection Moulding for Senior Technician course.

The classroom discussion and practical skills development will be conducted at a centralized Training Centre (actual venue to be confirmed/advised later).

Course Fees

Mandatory Registration fee – RM300/participant

Course Fee – RM3,000/participant**

**note: course fee will be fully funded by PSMB for qualified companies. For companies that does not meet the SME definitions, full course fee is applicable but claimable under the SBL scheme.

Please click here to download the brochure.

For enquiries, please contact Training Department, Ms Malathy or Ms Whendi Wong of MPMA Secretariat at tel: 603-7876 3027 or email: This email address is being protected from spambots. You need JavaScript enabled to view it.. For more information on the PSMB SME Skills Scheme, log on to the following link : https://www.hrdf.com.my/sme-skills/

 

© 2023 Malaysian Plastic Manufacturers Association. All Rights Reserved.

Disclaimer: MPMA shall not be liable for any loss or damage caused by the usage of any information obtained from this website.